Silicone mould – Saint Mary with aureole small
Silicone mould – Saint Mary with aureole small
In the large offer of Lyson Company you can find silicone moulds that allow you to make candles from beeswax.
Silicone moulds are made of flexible and durable silicone with plastic properties that enable their repeated use. Before the mould is filled with liquid wax, it is recommended to spray it with silicone spray. Silicone is also a preservative for the mould and a factor facilitating the removal of ready-made candles.
The variety of offered forms will give you the opportunity to make candles for every occasion.
Ready candles from beeswax can be freely decorated with quite popular decoupage technique or natural products, such as coffee beans, etc. Ready-made candle can be sprayed gently with silicone spray which will give it a shine. You can also add scented oils or colours to liquid wax for effects required. Candles make unique decoration as well as an original gift for family and friends.
You can make a candle of beeswax in a few simple steps. Items required:
- silicone mould,
- wick of appropriate thickness, matched to the size of the candle (the larger the candle, the thicker the wick)
- rubber band
- toothpick
- silicone spray (optional)
1. Preparation of the form
If you cast candles with a complicated pattern, you should spray it inside with silicone spray, it will be easier to remove the finished candle from the mould. Then cut off the appropriate length of the wick (it must be longer than the form) and drag it through the center of the mould - it should be taut. The next step is to put elastics around the form. At the end, stick the toothpick into the end of the wick and strain it well.
2. Pouring the wax into the mould
Dissolve the wax in a pot (preferably enamelled dish). Liquid wax should have suitable temperature of approx. 60°C. Pour the wax slowly so it reaches all hollowes. The setting time of the wax depends on the size of the silicone mould.
3. Removing the candle from the mould
When the wax is set pull the elastics, open the mould and gently take out the candle. Next, remove the toothpick and cut the wick at the base and leave about 1 cm at the top of the candle.
In the last step cut the bottom of the candle with a knife so the end of the wick can be soaked in warm wax.